Store | Gadget

Time machine add on parts for Delorean

FREE

Designer

GOODesign

GOODesign is a design studio established in Seoul, Korea by a representative who has been active in product design and 3D CG field for 20 years. As a design company that pursues a reasonable and differentiated digital design, it has always presented a new direction through working with clients such as Hyundai Motor, Siemens Korea and beiersdorf.   This time, we have put out the life product for 3D printing by utilizing various technique design based on the shape of the Class-A surface. These products are especially the result of deep research on the 3D printing dominant shape that can not be mass-produced using a mold.

This is the part that turns the folding car DMC into a time machine in the movie Back to the Future. There are six parts in all.

The order of attaching parts is as follows.

1. First remove the engine cover on the rear of the car and the parts on the side of the windshield.
2. The front time travel coil should be folded in two places and glued to the groove.
3. Apply glue to each of the parts of the rear side window of the car.
4. The rear long time travel coil folds the six slotted grooves inside.
5. Apply glue to the part that touches the body of the car and paste it from the upper part of the car to the side and the lower part in order.
6. Apply glue to the part( Nuclear Reactor / steam vents) on top of the engine cover.
7. Finally, Fold and paste Mr. Fusion.

Please refer to the video below and be sure to position and work before applying the glue.

Attachment process

PRUSA Slicing Settings Simplify 3D
Extuder Nozzle Diameter : 0.4mm / Retraction Distance : 2.4mm
Layer Settings Layer Height : 0.1mm, 0.2mm / Top Solid : 8 / Bottom Solid : 6 / Outline : 2
First Layer Settings First Layer Height : 100~150% / First Layer Width : 100% / First Layer Speed : 50%
Infill Interlor Fill Percentage : 10% / Outline Overlap : 30%
Additions Raft : OK / Brim : NO / Support : NO
PRUSA Slicing Settings Slic3r
PRUSA MK3 Layer Height : 0.1mm, 0.2mm / Raft : OK / Brim : NO / Support : NO
Ender Slicing Settings Simplify 3D
Extuder Nozzle Diameter : 0.4mm / Retraction Distance : 4~4.2mm
Layer Settings Layer Height : 0.1mm, 0.2mm / Top Solid : 8 / Bottom Solid : 6 / Outline : 2~3
First Layer Settings First Layer Height : 120% / First Layer Width : 100% / First Layer Speed : 50%
Infill Interlor Fill Percentage : 10% / Outline Overlap : 30~40%
Additions Raft : OK / Brim : NO / Support : NO
File
File 6.4 MB
Recommend Print
Material Color
Average Time
[0.1mm] TimeMachine : 1h 30m

Notice !

Feel free to talk about your product.
Comments that are irrelevant to the topic may be deleted

did you make it? please write making story !