Wall-E Foldable (Print-in-place Articulated)
FREE
You can download 1 free item per Free item - download ticket.

AUTOBOTO
Since Fab365 designed the Foldable Robot, there have been many requests to design the Wall-E in a foldable way. This is because Wall-E is optimized for foldable design. However, the shape optimized for foldable is only the body, and Wall-E's head/eyes, arms, wheels and track are a challenging shape with many factors to consider.
Now that we too have gained a lot of experience, we now have the skills to create, and finally we can design like this.
Please enjoy the foldable design skills that Fab365 has accumulated over the past 3 years with the Foldable Wall-E.
Here are some things to keep in mind when making Foldable Wall-E.
When folding the body, make sure to check the positions of the protrusions and holes before folding.
The parts attached to the upper corner of the Wall-E's body have a small adhesive area, so it is recommended to apply the adhesive carefully before sticking.
The neck must first be pushed up and then rotated before it can move.
The arm moves along the rail. On the lower rail, it moves well when the arm is forward, and on the upper rail, it moves well along the rail when raised up.
To make the track move well, it's a good idea to grease the wheels with sewing machine oil.
If the tracks are well separated, it is helpful to increase the flow rate.
Please check the video for details of the making process.
Printing on Prusa and assembling video ➪
Printing on Ender 3 and assembling video ➪
Largest part in printing, size = X 160mm, Y 184mm, Z 25mm
Notice !
Feel free to talk about your product.
Comments that are irrelevant to the topic may be deleted
did you make it? please write making story !
Write Review
Tengo una duda como hacer para mejorar las terminaciones tengo una hotnet uso cura q parámetros usan para ella use blanco para ver mejores las terminaciones para usar después el amarillo
Si alguno me ayuda buenísimo
good
My legs / wheels keep falling out. What is wrong? I hope someone can help me.
All prints fine with 0.1 layer. But the same problem:(
i have stopped the project . i have make it in trash . its possible to print but without information i recommand not to print because you spend a lot of time for nothing . finally its not possible to assembly it . For one who are new or whitout any experience about this project its better to stop.
i Think more information is better about infill , speed , e.t.c because this is very hard to find the right settings when you are new
Deleted
The body stl is missing the arms in the file I downloaded. In your assembly video they are either side of the square piece at the bottom and they are not in a seperate file. Can I get the correct file?
I found them, they were mislabelled as gray parts not yellow.
wqweqeqwqweqwe
I can't print the body, I tried everything, any advice? It is impossible for me to print the moving parts on the body, they are always glued on the 3rd layer with the body,
Material Pla
200º celsius
60º bed
nozzle 0'4 print 0.12
slicer cura
Thank you!
And Awesome job Fab365
Go to wall ordering if you're using cura slicer and change it into outside to inside with 1mm layer... Thank me by following or subscribing to my channel both ig and yt @lamka3dworld
Had fun with theses two