In case of printing out the existing scan data as it is, you need a number of support and take a lot of time to do postprocess, and people without its experience can hardly dare it. Also, the small printer losses the detailed part of this great data and is hard for people to watch. By supplementing this point, it was divided for anyone to print it out easy and largely regardless of a printer size.

It is recommended to turn on the support option for the part of support to be generated. However, the part, where the support is generated, is not visible after its assembly, and needs to have a simple post-process.
Most carefully, it is necessary not to let the output to be floated over the build plate floor due to the contraction in order to prevent the divided part from being visible.

The upper body and arm reaches less to build plate, and it is recommendable to set Raft or Brim wider than as usual so that it should not break away during the printing-out.

The order of adhesion is better to stick it from the lower part to the upper part, and to dry it for a long time by using a glue for paper and wood.

For printing this statue out, it is not necessary to lower the layer thickness too much to obtain the smooth surface. In spite of the layer thickness, it gives a feeling of being a patterned marble or cut tree, and it is better to use the settings of which 3D printer of yours prints out best.

It is highly used as an interior prop in any place that you want to produce a classical atmosphere (café, wine bar, library, living room & library etc.). And it is good for people to appreciate artwork, and helpful to study the history of Europe.