Store | Gadget

Floor Lamp

$ 5.99



It is a mood lighting using the wound frame design. It is the lighting designed by using the mechanical structure of woven pattern in harmony with the simplest sphere form. The bidirectional frame that intersects missed is so thin that it seems very weak, but in fact it is very strong as it is entangled and swirled mutually in opposite direction.

This structure uses less materials, while has less transformation by impact and force from several angles. Also this structure has a wide space among frames, and by allowing the heat to be easily discharged to this empty space it will not be transformed by the heat of illumination.

This mood lighting was designed to be conveniently put here and there in several places such as sofa or bed or floor of living room. This kind of lighting can make several productions as compared with most of uniform lighting that is put in fixed form. And putting many of them can produce more abundant atmosphere. The shadow made by the frame of lighting changes the flat surface of a wall into elegant atmosphere.

Aesthetically, it gives a feeling of being the oriental bamboo crafts as if you watch artistic handcrafts.

The interior lighting fixture was made to be easily produced by combining it with cheap lighting part that you can find from around, and repaired. However, you must use only LED bulb, because the common light bulb can be transformed as it emits lots of heat.

It was divided in small size by considering the maximum printing-out size of common desktop FDM 3D printer for more people to have this lighting fixture. Therefore, anyone who can have 3D printer or who can use it, though it is not an expensive 3D printer, can print it out.

Also it was designed to print out with some support in order to quit support, to finish and to reduce the process stress. And it was designed for anybody, though he cannot trim a support, to get a good result by preventing its trace from coming out in the way that support is generated inside even in case of needing a support. Of course, you will get the better product if printing out with a printer that allows the better result than FDM (for example, SLA, DLP, SLS etc.).

Each part of them was designed to combine with a small clip, and needing not much force to insert and quit it its coherence is rather so strong that it cannot be easily separated.

It can be used at anywhere including office, library, living room, bedroom etc., and can produce several atmospheres according to the brightness of bulb. Its whole size is 19cm (width) x19cm (depth) x31cm (height).

File 13.9 MB
Recommend Print
Replicator 2
Material Color
Average Time
[0.2mm] 44h

Notice !

Feel free to talk about your product.
Comments that are irrelevant to the topic may be deleted

did you make it? please write making story !