Ceiling Light-C (cube)
$ 3.99
GOODesign
GOODesign is a design studio established in Seoul, Korea by a representative who has been active in product design and 3D CG field for 20 years. As a design company that pursues a reasonable and differentiated digital design, it has always presented a new direction through working with clients such as Hyundai Motor, Siemens Korea and beiersdorf. This time, we have put out the life product for 3D printing by utilizing various technique design based on the shape of the Class-A surface. These products are especially the result of deep research on the 3D printing dominant shape that can not be mass-produced using a mold.
The interior lighting fixture was made to be easily produced by combining it with cheap lighting part that you can find from around, and repaired. However, you must use only LED bulb, because the common light bulb can be transformed as it emits lots of heat.
It was divided in small size by considering the maximum printing-out size of common desktop FDM 3D printer for more people to have this lighting fixture. Therefore, anyone who can have 3D printer or who can use it, though it is not an expensive 3D printer, can print it out.
It was designed with no support for printing out with a low-priced FDM 3D printer, and to obtain a clean output without a post-process.
The size of this Light is of 240mm (diameter) and 200mm (height).
| PRUSA Slicing Settings | Simplify 3D |
|---|---|
| Extuder | Nozzle Diameter : 0.4mm / Retraction Distance : 2.4mm |
| Layer Settings | Layer Height : 0.1mm, 0.2mm / Top Solid : 8 / Bottom Solid : 6 / Outline : 2 |
| First Layer Settings | First Layer Height : 150% / First Layer Width : 100% / First Layer Speed : 50% |
| Infill | Interlor Fill Percentage : 10% / Outline Overlap : 30% |
| Additions | Raft : OK / Brim : NO / Support : NO |
| Ender Slicing Settings | Simplify 3D |
| Extuder | Nozzle Diameter : 0.4mm / Retraction Distance : 4mm |
| Layer Settings | Layer Height : 0.1mm, 0.2mm / Top Solid : 8 / Bottom Solid : 6 / Outline : 2 |
| First Layer Settings | First Layer Height : 120% / First Layer Width : 100% / First Layer Speed : 50% |
| Infill | Interlor Fill Percentage : 10% / Outline Overlap : 40% |
| Additions | Raft : OK / Brim : NO / Support : NO |
Notice !
Feel free to talk about your product.
Comments that are irrelevant to the topic may be deleted
did you make it? please write making story !
Write Review
Hello! I just bought this design and I would like to ask you how to print it. on which side should the impression be oriented, so as not to have supports?
Thank you very much.
Ceiling Light-C (cube) requires only top part support. However, the support angle is set to 60 degrees, and the support is made in only the necessary part.
Adhesives must be used to assemble them. Use a strong adhesive and dry it for a long time.
Thank you!