FAB 365

Home < Cross & Twist Swirl Weaving Lamp

Cross & Twist Swirl Weaving Lamp

Living Light
$ 6.99

GOODesign is a design studio established in Seoul, Korea by a representative who has been active in product design and 3D CG field for 20 years. As a design company that pursues a reasonable and differentiated digital design, it has always presented a new direction through working with clients such as Hyundai Motor, Siemens Korea and beiersdorf.
This time, we have put out the life product for 3D printing by utilizing various technique design based on the shape of the Class-A surface. These products are especially the result of deep research on the 3D printing dominant shape that can not be mass-produced using a mold.

It is the third series of desktop lighting. Its difference from the second series is that the frame is twisted and the distance between frames becomes narrower that the area of emitting the direct light has been reduced. Accordingly, it shows more indirect illumination and gives a plentiful atmosphere. The bulb, with the mechanical structure of weaving pattern, is a lighting designed in harmony with the most common type of curve. The bidirectional frame that intersects missed seems very weak, but in fact it is very strong as it is entangled and swirled mutually in opposite direction. This structure uses less materials, while has less transformation by impact and force from several angles. Also this structure has a wide space among frames, and by allowing the heat to be easily discharged to this empty space it will not be transformed by the heat of illumination

The interior lighting fixture was made to be easily produced by combining it with cheap lighting part that you can find from around, and repaired. However, you must use only LED bulb, because the common light bulb can be transformed as it emits lots of heat. It was divided in small size by considering the maximum printing-out size of common desktop FDM 3D printer for more people to have this lighting fixture. Therefore, anyone who can have 3D printer or who can use it, though it is not an expensive 3D printer, can print it out. Also it was designed to print out with some support in order to quit support, to finish and to reduce the process stress. And it was designed for anybody, though he cannot trim a support, to get a good result by preventing its trace from coming out in the way that support is generated inside even in case of needing a support.

Of course, you will get the better product if printing out with a printer that allows the better result than FDM (for example, SLA, DLP, SLS etc.).

Each part of them was designed to combine with a small clip, and needing not much force to insert and quit it its coherence is rather so strong that it cannot be easily separated.
It can be used at anywhere including office, library, living room, bedroom etc., and can produce several atmospheres according to the brightness of bulb. Its whole size is 19cm (width) x19cm (depth) x31cm (height).


  • Makerbot Replicator 2


  • Black
  • White


  • [0.2mm] 52h 30m

Feel free to talk about your product. Comments that are irrelevant to the topic may be deleted


    Feel free to talk about your product. Comments that are irrelevant to the topic may be deleted