Needs more instructions

ipodfreek
2 2

Took me forever to figure out you have to squeeze the wheels to close the gap on the bottom. Now that I know this, it’s actually pretty cool.

Tell your friends!
Go to list

Comments 2

  • trinitron Anet ET5Cura
    2020-02-10 01:26:46

    0.2mm layer height?

  • fab365 Administrator
    2020-01-07 22:56:04

    Thank you for purchasing and posting. In your case, it appears that the edge of the print was raised during the printing process. Try to make the print stick to the bed. But, surfaces are very good~ Thank you again~