Best Model Yet !!!

Palumbo

truck, trailer, and box models were printed on a stock creality ender 5 @ 0.12mm layer height at 30mm/sec. i could have went faster but i wsnt in a rush to get the print done. and the results show !!

Tell your friends!
Go to list

Comments 6

  • trinitron
    2020-05-05

    Silky silver is best!

  • cubegram
    2020-04-05

    Which slicer and filament did you use?
    Very good print.

    Palumbo
    2020-04-20

    i used silver filament from iPrint 3D (Canadian) and i use Cura 0.12mm layer height, 60 for bed and 205 for hotend, 4 perimeters (wall, top and bottom) 15% infill

    https://www.iprint-3d.com/products/silver-pla-3d-filament?variant=35097301253

    cubegram
    2020-05-05

    Thank you for your answer~
    I think, I should consider buying the filament you used.

  • fab365
    2020-04-05

    Wow~ Awesome!
    You printed very well Foldable Peterbilt 379 sets, and Cyber Truck too~
    Thank you so much for sharing your experiences and photos~
    Stay safe and healthy~

    Palumbo
    2020-04-20

    thank you for the kind words, ive always enjoyed the work that you and your team put out, keep it up ;)