Still Having issues

brad4him4618

Hi, the snowman looks realy great and I have followed all the setting excatly as listed in Cura. Still having issues with small hor just above the left mitten and top left brim of the hat. I am using a 0.6 nozzel and increased the flow rate incrementally. I now up to 126 and still having issues with holes. Any suggestions? Printing with Kobra Max

Tell your friends!
Go to list

Comments 1

  • fab365
    2022-12-06

    I didn't tried 0.6 nozzle.
    But, the solution is, increase material flow and decrease print speed very slowly.
    Or change filament.