Printed ok at 0.1. Found it to be too loose, the wheels don’t stay up / under but I’m pretty sure I know what the issue is.
I also found the clip underneath too brittle and it snapped.
It’s still a great model though, I’m going to try again with some minor setting adjustments.
Printed in an Ultimaker 3, Metallic Silver PLA 0.1 layer height.
A little bit loose
2020-01-21
Hello there what was your problem ? I am having the same .
The metallic silver color is soft and luxurious. It's a rich light.
Surface quality is good~