I cant get this part printed correctly on my Prusa

huzargarden

I'm not sure if this is a problem only on my printer, but I tried different settings and different sheets on My Prusa MK3s+. Those small parts fail every time.

Tell your friends!
Go to list

Comments 2

  • huzargarden
    2023-03-06

    Hi, I tried your advice and even tested my prints, and all are sticking very well.
    There is a problem with the same parts with all my test prints. Those 2 elements are detaching from bed every time.

  • fab365
    2023-03-02

    This is obviously due to poor adhesion of the build bed. Apply something that increases the adhesion of the build bed or use a raft. Or you can rotate it and print it in a different orientation.
    Please check out the following printing tips.
    https://fab365.net/pages/14013138306/not_sticking_to_bed
    Thank you~