Great design, no support need

anthony77777821

It printed great with Prusa MK3S+
Filament: Prusament PLA Galaxy Black
Layer height: 0.2mm
No support
No need Vase mode
Print time around 12 hours

The eye part can heat up a bit with dryer to fit them into the mask.
There is a gap but I think it is not visble.

Tell your friends!
Go to list

Comments 1

  • fab365
    2021-11-02

    No layer marks are visible in your prints!
    The quality of the print is great, but I think the choice of filament was excellent!
    Thanks for the great print and posting!