I just finished printing this model on my anet a8 and to be honest it was total fail. I want to point out that its made for printing on prusa and ender so im not mad i just want to say that prints form anet a8 dont have that much quality that this model require and it will be waste of plastic. Altho i will print this again when i will finally have access to prusa.
Not for Anet a8
2022-07-03
I have a Anet A8.
Tip: please check if any screw is properly tied and test all calibrate settings (object dimensions, flow rate and bed leveling).
Recommended print speed: 50 mm/s
You can print at 100 mm/s if the upgrade is on (https://all3dp.com/1/anet-a8-upgrades-mods/).